流体力学的基本概念|门机械笔记
2.密度是根据粘度定义为动态粘度/运动粘度的。
3. The Reynolds number for pipe flow is given VDρ/µ.
4. SI粘度单位是10倍。
5.动力学粘度不是无量纲的参数。
6.最重要的重要性雷诺对管道流的数量对设计师来说并不重要。
7.圆柱体压缩的液体在1 mn/m2时的体积为1升,体积为995立方米,在Mn/m2时。弹性的大量模量为200 MPa。
8.在高度处的位置的汞柱长度将在地面上首先缓慢然后陡峭地变化。
9.由电阻引起的流体的体积变化称为粘附。
10.吸引其自身分子的液体的特性称为内聚力。
11.如果流体是粘性并且在运动中,则流体中某个点的压力不会相同。
12. Pitot tube can be used to measure the flow of water in a pipe of diameter 3000mm.
13.理想的液体是一种无摩擦且不可压缩的液体。
14.当速度向量在任何给定的瞬间在大小和方向上相同时,都会发生均匀的流动。
15.理想流体流的连续性方程式,即流体中到处都是恒定的。
16.忽视由于惯性,重力和摩擦力阻力引起的力,可以通过比较弗洛德的数字来设计通道的设计。
17. For smooth turbulent flow the friction factor changes as Nr1/4.
18.为了避免管道中的蒸发,将脊线上的管道线铺设的方式不超过液压梯度6.4 m。
19. The continuity equation is applicable to conservation of mass.
20. The rise or fall of head ‘h’ in a capillary tube of diameter ‘d’ and liquid surface tension ‘ σ‘ and specific weight ‘w’ is given by 4σ/wd.
21.用于低压测量的McLeod仪表符合博伊尔定律的原则。
22.液体的质量密度(ρ)由ρ= kg sec2/m4给出。
23.当调速器机构失败时,佩尔顿轮的跑步速度没有给予载荷速度。
24. A Kaplan turbine is low head axial flow turbine.
25. Vector difference of two velocities is relative velocity.
26.一艘船体长度为100 m的船舶是以10 m/秒的速度行驶。为了动态相似性,以2 m/s秒的速度以1:25的速度通过水拖曳1:25型号。
27.对于浮动体的稳定平衡,其元中心应位于重心上方。
28.倾斜平面上的压力中心位于质心下方。
29. The line of action of the buoyant force always acts through the centroid of the displaced volume of the fluid.
30.等电位线是没有速度分量切线的线条。
31.液压跳跃用于减少流量的能量。
32. The lowest portion to storage basin from where the water is not drawn, is dead storage.
33.皮托管是用于测量速度的设备。
34. Hydrometer is used to fine out specific gravity of liquids.
35. Mach number is signification is case of supersonics, as with projectiles and jet propulsion.
36.在Navier Stokes方程中考虑的流体力是重力,压力和粘度。
37.具有过度内部应力的岩石产生剥落,称为分层岩石。
38.流过混凝土隧道的水的允许速度通常为4-5 m/s。
39.在最不利的液压条件下,水力发电厂可获得的最大连续功率称为企业功率。
40. The ratio of maximum load to the rated plant capacity is called utilization factor.
41. Orifice refers to n opening in hydraulic structure with regulation provision.
42. The value of coefficient of discharge in comparison to coefficient of velocity is found to be less.
43.堰是指部分全流的开口。
44. Netwons的压力力在以25 m/s行驶的汽车的15 cm直径头灯为6.8。
45.当由于摩擦而导致的头部损失是所提供的总头部的三分之一时,通过管道传输的功率最大。







